*DISCONTINUED* not available (was $877)

Ken-Bar 4hp Beginner Single Seat Go-Cart Perfect for starting out the young go cart person in your family! Age range 5-8 years makes this a very sensible and safe machine for beginners with a gear reduction system built in to keep the maximum speed under 15mph (tested at approx 12.5mph).The baked-on polyurethane powder coat red finish has a single seat perfect for short(er) legs that can safely reach both the gas and brake pedals. A dependable Tecumseh 4.0 hp engine with a Centrifugal Automatic Clutch (no shifting) and a Live Axle (both rear wheels drive, both rear wheels stop!). Free Helmet and Safety Video included.

Go-Cart Specs Engine Tecumseh power sport 4-cycle, air cooled, gas powered engine Startability easy - pull recoil starter - capacitor discharge ignition Horsepower 4 hp Displacement 156 cc (9.53 cu in) Valve side Ignition CDI electronic Governor system quick response mechanical governor Gas tank no rust poly fuel tank Lubrication splash Exhaust system aluminized large quiet Drive System Two wheel drive live axle unit - two rear wheels drive Drive system centrifugal clutch Brake band Seat Single padded for one individual Adjustable pedals distance to pedals 24 1/2" TO 29 1/2" Performance All ball bearing (front & rear) This gives longer life and the hi-speed sealed bearings never need lubrication Top speed 12.5 mph (approximate) Live axle unit two rear wheels drive Tires Front 410 / 350 X 4" Rear 410 / 350 X 4" Frame Thick-walled steel strong 1" 11 gauge high quality steel tube Heavy gauge (thicker) frame most kart frames look the same from the outside, but there are major differences. Ken-Bar frames are made from extra-heavy duty 11 gauge steel. Many manufacturers use 14 or 16 gauge (the higher the number, the thinner it is), and some even use 18 gauge. All jig welded frames for accuracy Finish baked - on polyurethane powder coat Safety Safety video included with kart Seat belt (adjustable) Foam padded brush bars helps to protect the occupants against tree limbs. Safety flag Dimensions Height 41" Length 62" Width 32" Ground clearance 3 1/2" Distance to pedals adjustable pedals: 24 1/2" to 29 1/2" Weight 177 lbs. Available Colors RED ONLY Go-Cart Features Engine stop switch by steering wheel & on side of engine Side guard side bars help protect the occupants Free helmet! and safety video with every Ken-Bar Go-Cart Purchase Standard features found on all Ken-Bar Go-Carts All jig welded frames for accuracy! All ball bearing axles for long life! Powder paint for durability and finish! Seat belts on all vehicles! Brush Bars standard on all models Foam covered brush bars on most models Engines by Tecumseh! Torque converter by Comet! Clutches by Max-Torq! Go-Cart Notes • Unit comes 95% pre-assembled. Very minor assembly only, usually way less than an hour with normal household tools. Please read and understand your owners & safety manual, view your safety video tape (included) and then get ready for some major fun! • Speed and range specs are averaged, your ratings & experience may differ slightly. Warning! Go-Carts & Mini-Bikes can be hazardous to operate. Failure to understand and follow Warnings and Instructions for the safe use and maintenance of this product may result in Death or Injury! For your safety: Always wear an approved helmet, eye protection and protective clothing. Avoid stationary objects and obstacles that create the potential for collision. Avoid excessive speed and be particularly careful on difficult terrain. Never carry passengers. Never engage in stunt riding, jumping, or operate the vehicle under the influence of drugs or alcohol. Go-Carts & Mini-Bikes are for off road use only! Competent adult supervision is recommended when children are operating the vehicle. Check state and local laws for legal operation. Read Operator’s Manual and watch Safety Video. Go-Karts R us assumes no responsibilities or liabilities from the use or mis-use of this or any of our listings sold on this site. Use of this vehicle with age requirements is listed above in the items listing. Ken-Bar Go-Carts & Mini-Bikes comply with all standards for safety and performance per ANSI/SVIA-2001. Warranty & Parts Go-Cart Parts Ken-bar Manufacturing warrants to the original purchaser of its Go-Karts or Mini-bike, that if any part or parts (except engine) prove to be defective in materials and/or workmanship within 90 days. Bearing, wheel hubs, rims, chains, tie rod ends, steering spindles, throttle and brake pedals, brake drums and brake bands. No warranty on belts, clutches, throttle cables, worn out tires, and bent axles. One year warranty on frame breakage. Wrecked or abused, no warranty. Phone Ken-bar Mfg. for authorization to do the repair work. Retail customer must pay freight charge on parts to our plant and return. This warranty does not apply to any part, which is of the opinion of Ken-bar Mfg. Co., that rendered defective due to improper maintenance, improper assemble, alterations, abuse, negligence or accident. Warranty registration cards must be returned to Ken-bar. We will not honor a claim unless the card is mail to us within 10 days of purchase of Kart or Mini-Bike. Customer must view video after purchasing vehicle and put code number at end of video onto the registration card. To Order Ken-Bar Parts: You will need to use your breakdown illustration manual that came with your Ken-Bar machine (or if you don't have one simply download your Ken-Bar parts manual in our Ken-Bar Parts Manual Directory Listing). Once you have found the part #(s) you need within your parts manual... Method 1 Direct Search: Type the part# into the search box (located on every page in the left side boxes) and then hit Enter on your keyboard (or click on the icon next to the search box). This will bring up the part or if more than one part starts with that string, a choice will be displayed. Click on the part (link) you need and a "Add to Cart" button will be displayed towards the bottom of the items listing. Method 2 Category Drill Down: More time consuming than above method but has it's use. Use the Category box (located in the upper left side on every page) Click on the Parts Dept > Ken-Bar Parts this will display the Parts Categories. Choose the proper Parts Category that encapsulates your part #. Click on the part (link) you need and a "Add to Cart" button will be displayed towards the bottom of the items listing.